Thermo*Stop

Exterior Examples | Envelop Mouldings | Utility Trim  | Spa Elements(tm) |

 

Works where weatherstrip will not. Ideal for
DOORS & WINDOWS
  • Storage Areas
  • Garages
  • Workshops
  • Cellars
  • Crawlspaces
  • Utility Doors

is a unique combination of hard vinyl doorstop and soft vinyl weather strip. The bond is so tough that in normal use it won't even pull apart. When a door or window is opened, the weather-strip rides easily over moving ridges and imperfections without losing it's seal. Thermo*StopII 

Closes the gap around doors and windows.

Doors and most windows open. That means there is a gap around their frames to permit movement. The gap around roll up garage doors is huge.  A double garage door has about 32 feet of gap around the top and 2 sides.  Now you can make a garage door almost airtight with Thermo*Stop II!

Seals out dust,bugs and other flying debris

Wind swirling around a house infiltrates through the gaps around doors and windows. Dust and debris come with it. Ants, roaches, spiders, wasps and other insect invaders use these openings too.  Thermo*Stop II helps to keep out the dirt,rain and snow,cut grass and dead leaves by making these gaps weathertight . Your garage will stay much cleaner with Thermo*Stop II installed!!

 

Before Thermo Stop III After usin all PVC parts from Marley
Its the only doorstop that makes a rollup garage door weather tight!
 
Closes gap around and under a hinged door.

 

Stops air infiltration around loose fitting windows

 

Click for Installation InstructionsInstallation is fast and simple.
No special tools are necessary. A standard claw hammer removes your old wood doorstop or casing. Then all you need is a tape measure, marking pencil, saw, nails and scissors. For metal frames, you can attach Thermo Stop II with good quality weatherproof contact cement or screws. (Predrilling is required when installing at less than 32 degrees F.)

1.Thermo Stop II is installed on the door jam outside the door. Open door. Remove old doorstop with standard claw hammer.Close door.  2.Measure and make marks 1/2" from door at a number of places all around jamb. Connect marks with a straight line. Then open the door again. 3.Measure top opening from side to side and cut Thermo Stop II to fit. Use fine tooth saw and cut ends square.
4.Place grooved side against jamb and inner edge,( where hard vinyl joins weather-strip) on the line. Nail in place with 6d finishing nails about 6" apart. 5.Measure and saw each side piece to fit from top piece to floor. With grooved side against jamb and inner edge of hard vinyl on line, butt side piece against top piece and nail in place.

 

6.It may be necessary to trim soft vinyl weather-strip with scissors for a good overlapping joint at corners.

  

  Royal Mouldings Limited

135 Bear Creek Road    P.O. Box 610    Marion, VA 24354

Phone: (800) 368-3117  Fax: (276) 782-3292

Email: info@royalmouldings.com

 

Copyright©1999 - 2006 All Rights Reserved.

Royal Mouldings Limited

A Member of the Royal Group of Companies